Programming Scenes - Ghost Mydmx Manuel

2.2

Programming Scenes

Scanner buttons 1-12
3 4
11 12
MIDI/Rec
BANK
SCENE
1. Enter Program mode.
2. Press the Scanner button to turn on its fader control, which
is indicated by the lit LED.
You may select several scanners at a time by tapping of
these Scanner buttons, so you can assign several fixtures
at a time with this unit.
3. Create a desired scene using the faders.
The DMX value is 0 when the fader is fully down (bottom)
and 255 when it is fully up (top).
4. If necessary , you may tap the Page Select button to control
the second set of 8 DMX channels.
5. Once the scene is satisfactory, tap the MIDI/Rec button to
program this scene into memory.
6. Tap the Bank Up/Down button to select the bank you want
to store your scene into. There are total 30 banks you can
select, you may store up to 8 scenes into each bank.
7. Tap the Scene button to store your scene, all LEDs and the
Segment Display will flash three times briefly indicating this
operation, then the Segment Display will show the bank and
the scene.
Page 33