cahors CAP 532 Notice D'utilisation page 30

Antenna Power
RF-IN1
Antenna Power
Each input port (RF-IN1 to RF-IN4) is capable of supplying 12V, 100mA (max.) to an active
antenna. The user may choose to turn on/off the power on each input port based on the nature
of the antenna (passive or active) of user's choice.
Add Channel
On below LCD display:
RF-IN1
Ch14 ->14 77 dBμV
Input channel Output channel
NOTE: Due to automatic LTE filter selection capability of CAP 532, each input port can receive
VHF or UHF band signal only. To program it, the user needs to choose an input port and
associate a channel to it, and CAP 532 will automatically lock to VHF/UHF band based on the
command. In above case, the user has chosen Ch14, and that will lock RF-IN1 to receive UHF
band signal only. By removing all the channels associated to a specific input port, the user can
reprogram the input port to receive VHF/UHF band again.
Antenna Power
Off
Antenna Power
On
1. RF-IN1 refers to the desired signal input port. Ch14
refers to input channel. 14 refers to the output
channel. 77 dBμV refers to the input signal power
level (measured automatically by CAP 532).
2. Use Up/Down to change channel number, use
Left/Right to choose Input/Output channel
3. Press the Left button at Input Channel or press the
Right button at Output Channel to save settings and
go back to previous page
4. To avoid signal overlapping, Output Channel number
cannot be duplicated.
5. Maximum output channel numbers are 32
(RF-IN1 + RF-IN2 + RF-IN3 + RF-IN4 = Max 32)
7