Robern Entice Mode D'emploi page 10

INSTALLING THE CHARGING DOCK
09 | ENTICE OWNER'S GUIDE
TM
ATTACh TO ThE ACCESSOrY rAIL
1A. Open both wings outwards using the
tabs on the bottom of the charging dock.
1B. Angle the dock at 60 degrees. Then
insert the aluminum flange, centrally located
on the back of the dock, into the groove of
the M Series accessory rail. Pivot the front of
the dock downward into place.
SECUrE ThE DOCk IN PLACE
2. Position the charging dock in a
convenient location along the accessory
rail. Slide both wings down to secure the
charging dock into place.
PLUG IN ThE ChArGING DOCk
3. Using the supplied USB cord, plug the
micro end into the charging dock. Then
plug the standard end into a USB outlet,
located along the bottom of your M Series
electrical shelf.
(optional)