Oreck REVITALIZE Guide D'utilisation page 31

Problem Cause
Cleaner will • Clean Water Solution Tank is empty.
not dispense • Clean Water Solution Tank not installed properly.
• Needs service.
Hose nozzle will not • Air is trapped in the pump and hose.
spray after filling the • The connection to the tool port is loose.
Clean Water Tank or
Detergent Container
Motor noise becomes • Dirty Water Tank is full.
high-pitched • Dirty Water Tank is clogged.
• Air path is clogged.
• The float in the Dirty Water Tank has been activated.
Brushrolls are • Belt needs to be changed.
not spinning • Something is jammed in the brushroll.
• Needs service.
Resolution
• Fill Clean Water Solution Tank.
• Review Clean Water Solution Tank Installation.
• Take to service center. To find nearest location, visit our website at
www.oreck.com or call 1.800.989.3535.
• Turn on the cleaner. If hose does not spray, prime the pump by lowering
the hose down to the floor and hold the trigger for up to 1 minute.
• Ensure that the Hose is securely connected to the hose connection.
• Empty Dirty Water Tank.
• Clean Dirty Water Tank.
• Unclog air path.
• Review Emptying Cleaning the Dirty Water Tank.
&
• Refer to how to change belt.
• Remove jammed item from cleaner with unit turned off and unplugged.
31