Configuration - Elkron MR16 Guide D'utilisation Rapide

CONFIGURATION

Radio module MR16 operation is configured via DIP switch.
Command
DIP Function
switches
A1 - A2 The switches arm wireless devices
acquisition and removal steps
A3 Arm test
A4 Output relay operation mode for inputs
1÷16
A5 Output relay typology for inputs 1÷16
A6 Output relay typology SYS ST
A7 Output relay typology ON/OFF
A8 Output relay typology SAB / RF SAB /
BAT
B1 Outputs 1÷8 subordinated to radio
module status
B2 Enable jamming detection (radio
sabotage)
B3 Enable supervision
(radio sabotage)
B4 Enable radio module MR16 buzzer
B5 Enable PHYSICAL SABOTAGE alarm
B6 Input S polarity
B7 Inhibit sirens tamper for 1 hour
B8 Silence sirens audio warnings
Key
Settings
A1 A2
OFF OFF
ON ON
OFF ON
ON OFF
OFF = normal operation
ON = test procedure armed
OFF = bistable
ON = monostable
OFF = normally closed (NC)
ON = normally open (NA)
OFF = normally closed (NC)
ON = normally open (NA)
OFF = normally closed (NC)
ON = normally open (NA)
OFF = normally closed (NC)
ON = normally open (NA)
OFF = outputs subordinated
ON = outputs not subordinated
OFF = jamming control disarmed
ON = jamming control armed
OFF = supervision disarmed
ON = supervision armed
OFF = buzzer enabled
ON = buzzer disabled
OFF = physical sabotage alarm enabled
ON = physical sabotage alarm disabled
OFF = negative polarity
ON = positive polarity
OFF = siren rings at tamper opening
ON = siren does not ring if tamper is opened
within one hour from DIP switch having
switched over
OFF = sirens do not acoustically warn about
the change of status of radio module MR16
ON = sirens acoustically warn about the
change of status of radio module MR16
11
normal operation
acquire devices
remove a device
remove all devices