Operation - Wolf Garten LYCOS 40/480 V Mode D'emploi

EN
Risk of injuries
¾ Parts may only be fitted and removed
when the motor is switched off and the
power pack removed.
Assembly A B C D E F
Fitting the vacuum/blowing tube
Incline the top vacuum/blowing tube A a at a
Î
slight angle and press it first into the lower and
then the upper area of the device, until it audibly
locks into place B 1/2.
Screw the top vacuum/blowing tube securely in
Î
place using the screw B 3 .
Note
Only tighten the screw by hand.
Press the bottom vacuum/blowing tube A b
Î
against the upper vacuum/blowing tube until it
audibly locks into place C 1 .
Using the screws A f, screw the bottom vacuum/
Î
blowing tube tightly in place C 2 .
Adjusting the bow-shaped handle
Pull the adjustment lever to adjust the bow-
Î
shaped handle B 4 .
Select your preferred working angle B 5 and
Î
release the adjustment lever.
Attaching the transport wheel
Insert the transport wheel A c in the mounting on
Î
the bottom vacuum/blowing tube D .
Attaching the vacuum bag
Hook the vacuum bag A d on the front part of the
Î
casing connection E 1/2 .
Press the rear part of the vacuum bag adapter
Î
onto the connecting piece of the housing until it
audibly locks into place E 3 .
Attach the vacuum bag to the fastening
Î
hook E 4/5 .
Attaching the carrying belt
Attach the carrying belt A e to the fastening point
Î
provided F .
Note
For safety reasons only carry the device
supported over your shoulder and never
around your neck.
22
WARNING!
Adjusting the carrying belt
Adjust the carrying belt to the desired length. The
Î
attachment hook should be at hip height.
Note
In order that you have better control over the
device and so that your arms and back do
not tire too quickly, the carrying belt must
always be used with the device.
Inserting the power pack H
Incorrect handling of the power pack and
the charger
ÂRisk of injuries and material damage
¾ Read and observe the operating instruc-
tions of the power pack and charger.
The 2-stage latching mechanism is used to set oper-
ating or transport mode of the power pack.
Position 1 1
3 The power pack is in transport mode.
• The electric contacts are open to prevent the
power pack from self-discharge during storage.
Position 2 2
3 The power pack is in operating mode.
• The electrical contacts are closed and the de-
vice is ready for use.

Operation

Selecting the operating mode I
Set the selection lever to the desired operating
Î
mode.
NOTE
The selection lever can also be adjusted
during operation. Turn the selection lever,
always ensuring that it engages with the
corresponding symbol. Never move the
selection lever to an intermediate position.
- Vacuum function: Set the selection lever to
position 1 .
- Blow function: Set the selection lever to position
2 .
G
WARNING!
Operation