Assembly; Operation; Servicing - Wolf Garten LYCOS 40/740 B Mode D'emploi

Assembly

Assembly
Assembly A B C D E
Pick up the leaf blower casing and press the
Î
locating button B 1 .
Press the upper part of the blowing tube Aa on to
Î
the leaf blower casing B 2 .
The blowing tube comes with a shorter Ab and
a longer Ac attachment. Select according to the
application.
Press the attachment of your choice onto the
Î
blowing tube using a twisting movement, until it
locks in place C .
Attach the carrying belt Ad at the two hooks D .
Î
Note
For safety reasons only carry the device
supported over your shoulder and never
around your neck.
The optional rake Ae , is typically used to loosen
wet leaves from the ground.
To fit the rake, push it laterally onto the mounting
Î
on the long attachment E .
Inserting the power pack F
Incorrect handling of the power pack and
the charger
ÂRisk of injuries and material damage
¾ Read and observe the operating manual
of the power pack and charger.
The 2-stage latching mechanism is used to set oper-
ating or transport mode of the power pack.
Position 1 1
3 The power pack is in transport mode.
• The electric contacts are open to prevent the
power pack from self-discharge during storage.
Position 2 2
3 The power pack is in operating mode.
• The electrical contacts are closed and the de-
vice is ready for use.
WARNING!

Operation

Switching the device on G
The blowing speed level can be set using the contin-
uously adjustable adjustment wheel.
Set the desired blowing speed using the adjust-
Î
ment wheel (1 - 5) 1 .
Press the on/off switch 2 .
Î
3 The device operates.
Turbo mode
The leaf blower has an additional turbo mode for
extra high blowing speeds.
Press the turbo button to switch the function
Î
on/off 3 .
Working with the device
Hold the device with one hand on the handle, so
Î
that the thumb encircles the handle.
Direct the blowing tube towards the ground.
Î
Move slowly forwards in a controlled manner.
Î
Note
Use a lower speed for light material and a
higher speed for heavy material. Adjusting
the blowing speed or switching the turbo
function on/off can be performed with the
device running.
Switching the device off
Release the on/off switch I [12] to switch the
Î
device off.
Removing the power pack G
Press the power pack release 1 .
Î
Remove the power pack 2 .
Î

Servicing

Risk of injuries or material damage due to
moving parts.
¾ Always remove the power pack prior to
working on the device.
¾ Repair and service work as well as the
replacement of safety elements must
be performed by a qualified expert or
workshop.
WARNING!
EN
19