Adverse Reactions - Dentsply Maillefer X-SMART DUAL Mode D'emploi

Table des Matières

Les langues disponibles



Always clean the shank of the file to be installed. Allowing dirt to enter the chuck

could cause loss of concentricity and deterioration of chucking force.



Before changing the contra angle or the instrument (file), turn off the power of the

motor handpiece. Changing with the power on may cause unintended rotation by

accidental touch of the ON/OFF button.



For your own safety, please wear personal protective equipments (gloves, glasses,

mask).



If you do not use the product for a long period of time, remove the battery to avoid

fluid leak.



Confirm the battery has been inserted in the proper direction. Insertion in the wrong

direction may cause damage and fluid leakage due to a short circuit.



During operation, make sure there is always contact between the file and the fork.

Otherwise the apex position cannot be determined (Apex locator or dual modes).



Prior to the use of dual mode (Motor and apex locator), it is recommended to

determine the working length using the apex locator mode of the device only.

Notice



Fully-charged rechargeable batteries generally discharge gradually over time even

though the motor handpiece is not used. It is recommended to recharge the battery

just before use.



Should the product not be in use over an extended period of time (approximately 1

month), we recommend disconnecting the battery (See Chapter L. Maintenance for

instructions on inserting and removing the battery).



When the motor handpiece stops automatically by detecting a low battery voltage,

turning on the power again after a while may not detect the low voltage

immediately. This is not a failure, but is due to battery characteristics. Since the

voltage drop does not coincide with the remaining battery capacity, consider it only

as a benchmark.



When discarding the contra angle and motor handpiece, dispose of them as

medical waste.



Users are responsible for operational control, maintenance and inspection.



Storage conditions:

Temperature: - 10 to 60˚ C (14 to 140˚ F)

Humidity: 10 to 85% RH

Atmospheric pressure: 500 to 1060 hPa

The system should not be subject to air with dust, sulphur or salinity