Accessories; In-Car Connections - Philips EXP 301 Mode D'emploi

Accessories

In-car connections

Only use the AY 3545 car voltage converter (4.5 V DC, positive pole to
the centre pin) and the AY 3501 car adapter cassette. Any other product
may damage the set.
1
Put the set on a horizontal, vibration-free and
stable surface. Make sure it is in a safe place,
where the set is neither a danger nor an
obstacle to the driver and the passengers.
2
Connect the DC plug of the voltage converter
to 4.5V DC on the set (only for a 12 V car
battery, negative grounding).
3
Insert the voltage converter into the cigarette
lighter socket. If necessary, clean the cigarette lighter socket to obtain a good
electrical contact.
4
Turn down the volume and connect the adapter cassette plug to LINE OUT/p
on the set.
5
Carefully insert the adapter cassette into the car radio's cassette compartment.
6
Make sure the cord does not hinder your driving.
Set VOL E on the set to position 8. Start playback on the set and adjust
7
the sound with the car radio controls.
Always remove the voltage converter from the cigarette lighter socket
when the set is not in use.
Note: If your car radio has a LINE IN socket, it is better to use it for the
car radio connection instead of the adapter cassette. Connect the signal lead to
this LINE IN socket and to LINE OUT/p on the set.
24
(supplied or optionally available)
4.5 V DC
O
F F
• R
E S
U
M
E •
H O
L D
L IN
E O
U T
/
OP EN
L .
V O