Uberhaus 780-0001B Guide De L'utilisateur page 14

14. Assemble side shelf. Take left side shelf (26), align its back to front & back bracket and attach using M6*15
Phillips screw with washer. Repeat above steps for right shelf.
15. Assemble temperature gauge (18). Take off wing nut and flat gasket from temperature gauge,
put temperature gauge through main lid (19), then put on flat gasket, secure in place with wing
nut.(note: make sure orientating pin aligns with the elliptic hole on the main lid)
16. Assemble main lid handle tube (16). Take off wing nuts, spring washer and aluminum gasket from
main lid handle tube, put through main lid handle heat insulating spacer(17), then insert into main
lid, then put on aluminum gasket, hex nut, handle heat insulating plate, spring washer and finally
screw secure in place with wing nuts
Fig. 15
14
Fig. 14
Fig. 16