Uberhaus 780-0001B Guide De L'utilisateur page 11

7. Assemble control knob. Take 2pcs control knobs, align with holes on panel and press into gas
valve (7), make sure control knob LV roughly level with main control panel (allow 1 ~ 2 mm gap).
8. Assemble ignition module (9). Take off metal nut from ignition module and insert through the front
of main control panel, then tighten with metal nut.
Fig. 8
Fig. 7
9. Assemble main control panel. as shown in figure, connect gas tank heat insulating plate with tank
heat shield (5). Insert 4pcs M6*10 Phillips screws & washers through main control panel from inside
to outside, and separately lock in left side shelf bracket (front and rear) .
Fig. 9
11