Uberhaus 780-0001B Guide De L'utilisateur page 10

5. Assemble Cart Frame (13). Use ST 4.2 * 10 self-drilling screw to attach the gas tank heat insulating plate (41)
to the back panel, then use 4pcs M6*15 Phillips screws and washers to attach the cart frame to the left shelf
bracket (front and rear). (note: insert the front bottom screw through φ 7.5 hole of gas tank heat insulating
plate at the same time.) Repeat above steps for right cart frame.
Fig. 5
6. Assemble gas tank heat insulating plate and gas valve (7) on main control panel (10). Remove 2pcs
M5 * 8 screws from gas valve and align gas tank heat insulating plate to gas valve. As shown
below, align gas valve to the rear of main control panel, tighten with 2pcs M5*8 screws.
Fig. 6
10