Chauvet Professional ROGUE R1 FX-B Manuel De Référence page 3

Rogue R1 FX-B QRG
Power Linking
AC Plug
Replacing The
Fuse
Signal
Connections
Control
Personalities
DMX Connection
Art-Net™
Connection
sACN Connection
Kling-Net
Connection
You can link up to 8 Rogue R1 FX-B products at 120 V, 14 products at 208 V, or
15 products at 230 V. Never exceed this number. Power linking cords can be
purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
You can link the Rogue R1 FX-B to a controller or controller software using a DMX
connection, an Ethernet connection, or both. If using other Art-Net™, sACN, or
Kling-Net -compatible products with the Rogue R1 FX-B, you can control each
individually on a single network. See the User Manual for information about how to
connect and configure the product for these signals.
The Rogue R1 FX-B uses DMX, Art-Net™, sACN, and Kling-Net for its control
personalities:
Single Control
Tour 2 (52-channel)
Tour (47-channel)
Advanced (47-channel)
Standard (25-channel)
Basic (18-channel)
Uses DMX, Art-Net™, or sACN
The Rogue R1 FX-B will work with a DMX controller using a 3- or 5-pin DMX
data connection. A DMX Primer is available from www.chauvetprofessional.com.
Art-Net™ is an Ethernet protocol that uses TCP/IP which transfers a large amount
of DMX512 data using an Neutrik® etherCON® RJ45 connection over a large
network. An Art-Net™
www.chauvetprofessional.com.
Art-Net™ for best results.
Art-Net™ designed by and copyright Artistic Licence Holdings Ltd.
Also known as ANSI E1.31, Streaming-ACN is an Ethernet protocol that uses the
layering and formatting of Architecture for Control Networks to transport DMX512
data over IP or any other ACN compatible network. ACN is maintained by the
Professional Lighting and Sound Association (PLASA).
Kling-Net is a network protocol that allows auto configuration of display devices
using a Neutrik® etherCON® RJ45 Ethernet connection. Refer to the ArKaos
software manual for detailed instructions on programming this product.
For smooth-running operation, ArKaos Kling-Net requires a gigabit (1000
Mbps) Ethernet card and network router.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
Dual Control Movement
Advanced (23-channel)
Standard (17-channel)
Basic (10-channel)
protocol document
Chauvet Professional recommends using unicast
3
Screw Color
Brown Yellow/Brass
Blue Silver
Green
Dual Control Pixel
RGBW (20-channel)
RGB (15-channel)
Uses DMX, Art-Net,
sACN, or Kling-Net
is available
EN
from