Sunex Tools SXC610 Instructions D'utilisation page 2

FAILURE TO OBSERVE THESE WARNINGS COULD RESULT IN INJURY.
THIS INSTRUCTION MANUAL CONTAINS
IMPORTANT SAFETY INFORMATION.
READ
CAREFULLY
INFORMATION BEFORE OPERATING THIS
TOOL.
• Always operate, inspect and maintain this
tool in accordance with American National
Standards Institute Safety Code of Portable
Air Tools (ANSI B186.1) and any other
applicable safety codes and regulations.
• For safety, top performance and maximum
durability of parts, operate this tool at 90
psig/6.2 bar max air pressure with 3/8"
diameter air supply hose.
• Always wear impact resistant eye and face
protection when operating or performing
maintenance on this tool. Always wear
earing protection when using this tool.
• High sound levels can cause permanent
hearing loss. Use hearing protection as
recommended by your employer or OSHA
regulation.
• Keep
condition.
• Operators and maintenance personnel must
be physically able to handle the bulk, weight
and power of this tool.
• Air under pressure can cause severe injury.
Never direct air at yourself or others. Always
turn
hose of air pressure and detach tool from
air supply before installing, removing or
adjusting any accessory on this tool, or
before performing any maintenance on this
tool.
in injury. Whip hoses can cause serious
injury.
frayed or loose hoses and fittings, and
replace immediately. Do not use quick detach
couplings at tool. See instructions for correct
set-up.
• Air
in use. Vibration, repetitive motions or
uncomfortable positions over extended
periods of time may be harmful to your
hands and arms. Discontinue use of tool if
discomfort, tingling feeling or pain occurs.
Seek medical advice before resuming use.
SXC610
THIS INSTRUCTION MANUAL
AND UNDERSTAND
the tool in efficient operating
off the air supply,
Failure to do so could
Always check for damaged,
powered tools can
ALL
drain
result
vibrate
2
• Place the tool on the work before starting the
tool. Do not point or indulge in any horseplay
with this tool.
• Slipping, tripping and/or falling while
operating air tools can be a major cause of
serious injury or death.
of excess hose left on the walking or
work surface.
• Keep body working stance balanced and
firm. Do not overreach when operating the
tool.
• Anticipate and be alert for sudden changes
in motion during start up and operation of
any power tool.
• Do not carry tool by the hose. Protect the
hose from sharp objects and heat.
• Tool shaft may continue to rotate briefly
after throttle is released. Avoid direct contact
with accessories during
use. Gloves will reduce the risk of cuts
or burns.
• Keep away from rotating end of tool.
Do not wear jewelry or loose clothing.
Secure long hair. Scalping can occur
if hair is not kept
tool and accessories. Choking can occur if
neckwear is not kept away from tool
and accessories.
• Correct grinding wheel mounting is necessary
to prevent injury from broken wheels. Do not
use chipped or cracked grinding wheels
Grinding wheels should be a free fit on the
spindle to prevent stress at the hole. Use only
wheel collars that come with the grinder for
mounting the grinding wheel. Flat washers or
other adapters may over stress the wheel.
Always use heavy paper blotter discs between
the wheel collars and the grinding wheel
Tighten the wheel on the spindle to prevent
spin off when the air grinder is turned off.
• Do not lubricate tools with flammable or
volatile liquids such as kerosene, diesel or jet
fuel.
• Do not force tool beyond its rated capacity.
• Do not remove any labels. Replace any
damaged labels.
• Use accessories recommended
Sunex Tools.
Be aware
and after
away from
by
Rev. 01/11/05