Greenlee Intelli-PUNCH Mode D'emploi page 4

IMPORTANT SAFETY INFORMATION
A component failure could throw
broken parts.
• Do not allow anyone to stand in
front of the punch or behind the
hydraulic ram.
• Close access doors or covers on
any equipment that is in line with
the punch or ram.
Failure to observe this warning
could result in severe injury or death.
Do not attempt to punch a hole
through two or more layers of mate-
rial. This will bend or break the draw
stud, and could throw parts with
great force.
Failure to observe this warning
could result in severe injury or death.
Set up the tool properly. An improper setup could
cause a component to fail and strike nearby person-
nel with great force.
• Use only Greenlee punches, dies, and draw studs.
Other manufacturers' components might not with-
stand the forces generated by this punch driver.
• Manual Punch Setup: The punch must be
threaded completely onto the draw stud. All of
the punch threads must be engaged by the draw
stud threads. Incomplete assembly could cause a
component failure.
• Hydraulic Punch Setup: The draw stud must be
threaded completely into the driver head. The
punch must be threaded completely onto the draw
stud. All of the punch threads must be engaged by
the draw stud threads. Incomplete assembly could
cause a component failure.
• SPEED PUNCH Setup: The draw stud must be
threaded completely into the driver head. The
SPEED LOCK must fully engage and completely
close on the draw stud. Incomplete assembly
could cause a component failure.
Failure to observe these warnings could result in
severe injury or death.
Greenlee / A Textron Company
Intelli-PUNCH™ Knockout Driver
• Inspect tool for wear or damage. Replace any
worn, damaged, or missing components with
Greenlee replacement parts. A damaged or
improperly assembled tool can break and strike
nearby personnel with sufficient force to cause
severe injury or death.
• Inspect the punch, die, draw stud, and spacers for
wear or damage. Replace any worn or damaged
items with Greenlee replacement parts. Replace
any punches that have dull cutting surfaces.
Do not exceed the rated capacity of this tool.
Exceeding the rated capacity could cause a com-
ponent failure, which could throw broken parts with
great force.
Failure to observe this warning could result in severe
injury or death.
Do not dispose of batteries in a fire. They will vent
fumes and may explode.
Failure to observe this warning could result in severe
injury from harmful fumes or burns from flying
debris.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070