Lcd Contrast; Display View - Kronos 50 Manuel D'installation

Paragraph 12
Programming
Alarm Relay
N.Open
Paragraph 13
Programming
Max Flow Rate
100%
9. Maintenance
9.1 Tubing change
With the pump in Stop (press the
anticlockwise at the minimum speed in order to facilitate the removing hose, to terminate the running pump press
k ey.
the
With the same procedure, by pressing the
speed in order to facilitate the replacing hose, to terminate the running pump press the

9.2 LCD Contrast

With the pump in Stop (press the
contrast.

10. Display view

10.1 During the dosage
Mode:
•
•
•
•
•
•
0000137630
10.000 L
k ey),
b y pressing the
k ey
k ey), b y
p ressing the
Manual Mode
mA Mode
Batch Mode
1:N Mode
N:1 Mode
PPM Mode
PPM Mode
Priming
Message:
Priming
•
LEVEL
•
MOTOR
•
No Trg
•
Rev. 2.0
This makes it possible to set the alarm relay as follow:
N.Open= normally open.
•
N.Closed= normally closed.
•
This makes it possible to set the maximum flow offered by
the pump, and the programmed mode (% or frequency) is
used as the standard unit of measurement when displaying
the flow.
k ey
f or at least 3 seconds the pump run
f or at least 3 seconds the pump run clockwise at the minimum
and
Memory:
ON
•
OFF
•
M mem
P100%
Dosing %
Operation
Operation
k ey.
keys to increase or decrease the
Memory Status:
mem (memory active)
•
(no memory)
•
14