Fellowes Proteus A3 Instructions D'utilisation page 7

THERMAL RE-SET
TROUBLESHOOTING
Problem
No power
Ready light does not come on after a
long period
Pouch does not completely seal the item
Pouch has waves or bubbles
Pouch is lost in the machine
Jamming
Pouch is damaged after lamination
Curled or burnt laminations
Soft or poor lamination
Rollers not running
Unstable lamination temperature
Cannot select any Mode
Rollers not running & motor is running
Excessive noise
Repeated faint line on lamination
Laminator will not reset
Possible cause
Machine not switched on
Main fuse failure
Power cord not fitted correctly
Machine is not heating up
Item may be too thick to laminate
Temperature setting may be incorrect
Temperature setting may be incorrect
Pouch is jammed
Pouch was inserted 'open end' first
Pouch was not centred on entry
Pouch was not straight upon entry
Empty pouch was used
Damaged rollers or adhesive on rollers
Too hot
Too cold
Rollers too cold (< 60°c)
"STOP" button may be pressed
Roller electric brush may be broken
Circuit board error
Loose circuit bolts on gear
Gears worn or damaged
Roller damaged
Too hot
The machine is supplied with a thermal re-set switch. The switch will activate
when the machine becomes too hot. This condition should not occur during
normal use. To re-set the switch:
it snaps closed.
Solution
Switch on machine at rear next to plug inlet and at the wall socket
Replace fuse
Check power cord in receptacle on unit
Contact service dealer
Pass through the machine again
Check pouch thickness is correctly selected and pass through again
Check pouch thickness is correctly selected and pass through again
Select reverse button and pull out the item by hand
Pass cleaning sheets through the machine to test and clean rollers
Reduce temperature or increase speed
Increase temperature or reduce speed
Wait for rollers to warm-up
Press "MOTOR" or "SPEED" button
Contact service dealer
Allow laminator to cool down
7