djive FLOWMATE Classic 120 Mode D'emploi page 12

ASSEMBLY \\\
Fan assembly
1. Loosen the locking screw on the bottom of the fan head and align the fan
head to the top of the inner pole. Tighten the locking screw to
attach the fan head to the fan body.
Tilt adjustment
To adjust the air flow, the tilt angle can be adjusted. To do this, loosen the tilt
adjustment screw and adjust the fan head to the desired angle. Tighten the
tilt adjustment screw to fix the position.
Height adjustment
To adjust the height of the fan, loosen the height adjustment screw on the
outer pipe and push the inner pipe up/down to the desired height. Tighten
the height adjustment screw to fix the fan in place. The fan height can be
adjusted from 90cm to 120cm.
The fan should be switched off before making any adjustments.
12