Assembly - djive FLOWMATE Classic 120 Mode D'emploi

ASSEMBLY \\\

Remove all small parts from the box.
Base assembly
1. Loosen and remove the base
locking screw and washers
from the bottom of the pipe.
2. Fit the pipe into the recess in the top side of the base; and while
holding it, turn it over to access the underneath.
3. Align the big washer, small washer and the base locking screw against
the hole. Rotate the base locking screw to finish attaching the base to
the fan body.
4. Now turn it theright way up
and place on a flat stable
surface.
11