Initial Settings; Quick Edit - Korg ToneWorks PANDORA PX4B Notice D'emploi

Initial Settings

1. When you finish making connections, set the
power switch in the "ON" position. (This set-
ting is referred to as Play mode.)
Use the L/M buttons to select a program.
2. Set the input level switch to a position appro-
priate for the output level of your bass.
Hi: Basses with a high output level (Active)
Lo: Basses with a low output level (Passive)
3. Set the volume control of the bass to its usual
position. Use the Value dial to adjust the mas-
ter level.
If you want to use the infrared transmitter func-
tion, refer to p.26 of Edit mode, "8) TX (Infrared
transmitter)."
12

Quick Edit

In each mode (except when Mute/Bypass or Key
Lock are active), you can use the Amp Model-
ing selector to quickly change the amp model-
ing type, or use the control knobs to adjust the
tone, or volume of amp modeling. When you move
a control knob, the parameter name and value
will appear for several seconds in the value dis-
play. If the setting matches the original setting,
the ORIG icon will light.
The Delay Time of Delay Modeling can also be set
by pressing the TAP button twice at the desired
interval (except when in Rhythm mode). To check
the Delay Time that was specified, press and hold
the TAP button for two seconds or longer.
When you use the Amp modeling selector to
choose an amp, the PX4B will automatically
select the most suitable cabinet model and turn
it on.
Settings that you make using Quick Edit will re-
turn to the original settings of the program if you
change programs or turn off the power before
Writing (see p.26).