Suggested Uses - Campbell Hausfeld AT122700 Instructions D'utilisation Et Manuel De Pièces

Suggested Uses

Type of abrasive
(Sieve/Size) application
Sand Etching and
drilling holes in glass
(30-50)
Glass beads
Sand (40) Antiquing or
Ground walnut weathering wood
shells
Sand (50-100) Glass Wood sanding and
beads, ground refinishing furniture
walnut shells
Sand Cleaning barbeque
(20-40) grills and iron pots
Sand (20-40) Cleaning automotive
Aluminum oxide parts
Sand Cleaning and stripping
(20-40) masonry
Ground pecan or Cleaning or preparing
walnut shells and for paint
corn cob meal
Sand (20-50) Cleaning or stripping
Aluminum outdoor equipment
oxide (50-80)
Distance
from work pSI
1 - 4 inches 40 - 90
2 - 6 inches 40 - 90
1 - 6 inches 40 - 70
1 - 4 inches 50 - 125 Be sure to mask any glass or painted surface that
1 - 4 inches 40 - 80
1 - 4 inches 50 - 125 Use a heavy grit sand with a sweeping overlapping
1 - 6 inches 40 - 125 Use brushing strokes and watch the abrasion rate
1 - 3 inches 50 - 125 Remove flaking paint first with wire brush, then
5
Suggestions
Move gun back and forth over the template in
a brushing manner . Blast at a 90° angle . For fine
polishing, use glass beads for the abrasive . For
drilling holes, use 30 sieve sand .
Use brushing strokes and watch the abrasion
rate carefully . Soft wood will wear faster than
hardwood . Smaller grit sizes gives smoother finish .
Start with low pressure and gradually build up
pressure . Blast at a 45° angle .
Use brushing strokes and watch the abrasion rate
carefully . Use walnut shells for coarse finishing and
glass beads or fine sand for fine finishing . Blast at a
45° angle .
could be accidentally damaged . Blast at a 80 - 90°
angle .
Use larger grit sand on a hidden area . If the base
material is being damaged, use a smaller grit . Blast
at a 80 - 90° angle .
stroke . Blast at a 80 - 90° angle .
carefully . Soft wood will wear faster than hard
wood . Smaller grit sizes five a smoother finish . Start
with low pressure and gradually build up pressure .
Blast at a 45 - 60° angle .
sandblast with a heavy grit abrasive . Multiple
layer of old paint should be scraped first . Prime
immediately following sandblasting to prevent
corrosion . Blast at a 45 - 60° angle .
aT122700
www.chpower.com