Campbell Hausfeld AT122700 Instructions D'utilisation Et Manuel De Pièces page 2

Operating Instructions and Parts Manual
General Safety Information
(Continued)
create static electricity while you are
sand blasting. If you are not grounded,
the static electricity can build up on
your body and cause a shock when
you touch a metal object. You can
avoid static electricity by wearing
leather soled shoes and standing on
the ground. If necessary, a grounded
wire attached to the sand blast gun
will safely remove the static electricity.
Remember, you are not grounded if
you are insulated from the ground.
Rubber soled shoes, rubber boots, or
other rubber or plastic footwear are
insulators. Avoid standing on dry wood
(like a wooden pallet) a dry mat, or dry
carpet.
GEnEral SafETy
• Read all manuals included
with this product carefully .
Be thoroughly familiar
with the controls and the
proper use of the equipment . Follow
all instructions .
• Only persons well acquainted with
these rules of safe operation should
be allowed to use the unit .
Do not misuse
this product.
Excessive exposure to vibration, work in
awkward positions, and repetitive work
motions can cause injury to hands and
arms. Stop using any tool if discomfort,
numbness, tingling or pain occur, and
consult a physician.
1 . Read this instruction manual before
connecting this device to the
compressor .
2 . Safety glasses or face shield, gloves
and a NIOSH approved respirator
must be worn during operation .
Always work in a well ventilated
area .
figure 1
www.chpower.com
3 . Always wear hearing
protection when using the
tool . Prolonged exposure
to high intensity noise is
able to cause hearing loss .
4 . During operation, do not expose the
hands or skin directly in the line of
the blast nozzle .
5 . After installation, inspect to make
sure all components seal properly .
6 . Keep children away at all times . All
visitors must be kept a safe distance
and wear safety glasses, gloves and a
respirator .
7 . Do not exceed the maximum
operating pressure of the
sandblasting equipment (125 psi) .
Disconnect the
sandblaster
from the air supply before changing
accessories or attempting to install,
service, relocate or perform any
maintenance.
8 . Check hoses and air lines for weak
or worn condition before each use .
Make sure all connections are secure
before use .
Do not point the
sandblast gun
at anyone or objects other than the
intended work object.
9 . Do not depress the trigger when
connecting the air supply hose .
Do not work around
oily rags or
flammable liquids. Sand striking metal
can cause a spark and create a fire or
explosion.
MoISTUrE In CoMprESSED aIr
Moisture in compressed air will form into droplets as the air comes from
the compressor pump . When humidity is high or when a compressor is in
continuous use for an extended period of time, moisture will collect in the
tank . When using a sandblast gun, this water will be carried from the tank
through the hose and out of the gun as droplets mixed with the material
being sprayed .
IMporTanT: THIS CONDENSATION WILL CAKE THE SAND AND CLOG THE
SANDBLASTING GUN . A CLOGGED GUN WILL NOT OPERATE .
A compressed air dryer and/or air line filter will help eliminate this moisture .
2
figure 2
Do not spray acids
or caustics.
figure 3