Testing Grains That Are Above Or Below The Limits; Displaying The Averaged Moisture Results; Clear Grain Averages - AgraTronix MT-PRO+ Manuel De L'opérateur

TESTING GRAINS THAT ARE ABOVE OR BELOW THE LIMITS

If the grain being tested in the tester is above or below the grains calibration
limits the tester will display a < (less than) or > (greater than) symbol followed
by the tested grain's upper or lower moisture limit. Even though the tester can't
display a valid moisture result this information is still useful because you still
know the range above or below that the tester can display.
Grains that are above or below the limits are not stored for averaging.
NOTE:

DISPLAYING THE AVERAGED MOISTURE RESULTS

1. Each time a moisture test is taken the averaged moisture result is
automatically displayed along with the current moisture and temperature.
2. The averaged results are stored for each individual grain, so when switching
between grains there is no need to clear the averaging results as the tester
calculates the average for each grain individually.
3. The tester by default will display the averaged results of the last selected
number of tests performed on the tested grain. (The default is the average of
the last 3 tests)
CLEARING GRAIN AVERAGES
1. You can clear the average result for the current grain (Last grain tested) or
all grains.
2. To clear the average, while in the grain menu press the "UP OR DOWN"
buttons until "OPTIONS" is selected then press the "ENTER" button.
3. The "OPTIONS" menu will now be displayed, press the "UP OR DOWN"
buttons until "CLEAR AVG" is selected then press the "ENTER" button.
4. The "CLEAR AVG" menu will be displayed. Press the "UP OR DOWN"
buttons to select either "CURRENT GRAIN" or "ALL GRAINS". If
"CURRENT GRAIN" is selected, the current grain's average will be cleared.
If "ALL GRAINS" is selected, all grain averages will be cleared.
5. Once you have selected the correct selection press the "ENTER" button the
words "CLEARING" and a trash can will be displayed to confirm that your
averages have been cleared.
6. If you don't want your selection to be saved simply press the "BACK
ARROW" button and you will be returned to the previous menu without
saving your selection.
Operation
10-7