Napa 791-5070 Manuel De Fonctionnement Et Liste Des Pièces

791-5070_man092303 9/23/03
THIS OPERATING
IMPORTANT SAFETY INFORMATION.
READ CAREFULLY AND UNDERSTAND ALL
INFORMATION BEFORE OPERATING TOOL.
SAVE THIS MANUAL FOR FUTURE USE.
DO NOT OVERLOAD. OVERLOADING CAN CAUSE DAMAGE TO, OR FAILURE OF
THE STAND.
THIS STAND IS DESIGNED FOR USE ONLY ON HARD LEVEL SURFACES CAPABLE OF
SUPPORTING THE LOAD. USE ON OTHER THAN HARD LEVEL SURFACES CAN RESULT IN
STAND INSTABILITY AND TIPPING OF LOAD.
LOCK THE MOUNTING-PLATE ROTATING MECHANISM BEFORE APPLYING A LOAD.
RELEASE ROTATIONAL LOCKING DEVICE SLOWLY AND CAREFULLY.
ALWAYS USE HIGH STRENGTH SAE GRADE 8 BOLTS FOR ENGINE MOUNTING BOLTS.
MAKE SURE WIDEST SET OF MOUNTING HEAD FINGERS ARE NEAREST THE GROUND
WHEN MOUNTING AN ENGINE TO THE STAND.
ALWAYS BE SURE THAT THE LOAD IS CENTERED AND SECURED TO THE MOUNTING PLATE.
OFF-CENTER LOADS MAY MAKE THE LOAD AND HANDLE ROTATE IN EITHER DIRECTION
WHEN THE ROTATIONAL LOCKING DEVICE IS RELEASED.
NEVER LOOSEN MOUNTING BOLTS UNLESS ENGINE IS SUPPORTED BY A CRANE
OR HOIST.
DO NOT USE STAND TO DOLLY OR TRANSPORT ENGINES.
NO ALTERATIONS TO THE STAND OR ADAPTERS SHALL BE MADE.
DO NOT ROTATE MOTOR UNLESS REAR LEGS ARE SECURED FROM TIPPING.
READ, STUDY AND UNDERSTAND ALL INSTRUCTIONS BEFORE OPERATING.
FAILURE TO HEED THESE WARNINGS MAY RESULT IN LOSS OF LOAD, DAMAGE
TO STANDS, AND/OR FAILURE RESULTING IN PROPERTY DAMAGE, PERSONAL OR
FATAL INJURY.
REFER TO ENGINE SERVICE MANUAL FOR CORRECT LIFTING
POINTS, MOUNTING POINTS AND MOUNTING BOLTS!
MOUNTING BOLTS SHOULD BE TORQUED AT APPROPRIATE
AMOUNT TO MAINTAIN LOAD.
7915070
4:42 PM Page 1
MANUAL CONTAINS
1000 LB. GEARED
OWNER/USER RESPONSIBILITY
The owner and/or user must have a thorough understanding
of the manufacturer's operating instructions and warnings
before using this engine stand. Personnel involved in the use
and operation of equipment shall be careful, competent,
trained, and qualified in the safe operation of the equipment
and its proper use when servicing motor vehicles and their
components. Warning information should be emphasized
and understood. If the operator is not fluent in English, the
manufacturer's instructions and warnings shall be read to
and discussed with the operator in the operator's native
language by the purchaser/owner, making sure that the
operator comprehends its contents.
Owner and/or user must study and maintain for future
reference the manufacturer's instructions. Owner and/or
user is responsible for keeping all warning labels and
instruction manuals legible and intact. Replacement labels
and literature are available from the manufacturer.
DO NOT CRAWL UNDER ENGINE OR PLACE ANY PART OF YOUR
BODY UNDER ENGINE AT ANY TIME DURING MOUNTING OF
ENGINE, USE OF STAND, OR REMOVAL OF ENGINE.
1
MODEL # 791-5070
ENGINE STAND
09/23/03