Napa 791-2004 Guide D'utilisation

BEFORE USING THIS DEVICE, READ THIS
MANUAL COMPLETELY AND THOROUGHLY,
UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND
MAINTENANCE REQUIREMENTS.
It is the responsibility of the device owner to make sure all personnel
read this manual prior to using the device. It is also the responsibility
of the device owner to keep this manual intact and in a convenient
location for all to see and read. If the manual or product labels are lost
or not legible, contact NAPA for replacements. If the operator is not
fluent in English, the product and safety instructions shall be read to
and discussed with the operator in the operator's native language by
the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
SPECIFICATIONS
Capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5/8 Ton
Length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33-1/4"
Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33-1/2"
Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33-1/2"
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85 lbs .
791-2004
• Read, study, understand & follow all instructions before
using. • User and bystanders must wear eye protection
that meets ANSI Z87.1 and OSHA standards. • Inspect the
engine stand before each use. Do not use if damaged,
altered, modified, in poor condition, or has loose or missing
components. Take corrective action before using the
engine stand. • Do not use (or modify) this product for any
other purpose than that for which it was designed without
consulting the manufacturer's authorized representative.
• Do not use beyond rated capacity. • Use only on a
hard level surface capable of supporting the load. • Lock
mounting plate rotating mechanism before applying a load.
• Make sure all mounting hardware is securely tightened
and setup is stable before rotating engine. • Always use
high strength SAE grade 8 bolts for mounting engine to
mounting head fingers. • Make sure widest set of mounting
head fingers are nearest the ground when mounting engine
to stand. • Assure the load is centered, balanced and
secured to the mounting head and fingers. The engine's
weight should be balanced within 1" of the mounting
head's rotational axis. • Release rotational locking device
slowly and carefully. Off center load may make the load and
handle rotate in either direction when the rotational locking
device is released. • Rotate the engine using the handle for
device provided. • Lock the wheels and/or casters before
working on the engine. • Adequately support the vehicle
before starting repairs. • Never loosen mounting head
bolts or engine mounting bolts unless engine is supported
by a crane or hoist. • Only attachments and/or adapters
supplied by NAPA shall be used. • Do not use stand or
dolly to transport engine. • Do not crawl under engine or
place any part of your body under engine at any time.
• Refer to engine manufacturer's service manual for proper
lifting points, mounting points and bolt sizes. Mounting
bolts should be torqued at appropriate amount to maintain
load. • This product contains chemicals known to the state
of California to cause cancer and birth defects or other
reproductive harm. Wash hands thoroughly after handling.
• Failure to heed these warnings may result in serious or
fatal personal injury and/or property damage.
1
Model # 791-2004
5/8 Ton
engine STand
WARNING
rev. 12/17/15