Basic Configuration Of Dome Camera System - Eneo IPP-72A0023MIA Guide D'installation Rapide

CAUTION 2: Before installing mounting bracket to surface pre-adjust the four mounting
screws "A" on the base of the dome camera to best match the mounting bracket locked
position. Unscrew the locking screw on the side of the dome's base and fit the tab of the
mounting bracket into the locking slot. Screws "A" should not be too tight or too loose
when the dome is in the locked position. After setting the proper positions of screws
"A" remove the mounting bracket and install it to the proper surface. If it is too difficult
to lock the dome in position after the mounting bracket has been installed readjust the
screws "A" by unscrewing them a small amount and try to install dome camera again.

Basic Configuration of Dome Camera System

No. Connector
1 RJ-45
2 DC JACK
3 3-PIN TERMINAL BLOCK
4 3-PIN TERMINAL BLOCK
5 2-PIN TERMINAL BLOCK
6 2-PIN TERMINAL BLOCK
7 2-PIN TERMINAL BLOCK
The camera must be installed by qualified service personnel in accordance with all local
and federal electrical and building codes.
8
Description
Ethernet, RJ-45 port compatible with 10/100Mbps having PoE functionality
CAMERA POWER (12VDC)
A1: ALARM INPUT 1
A2: ALARM INPUT 2
G: GND
A3: ALARM INPUT 3
A4: ALARM INPUT 4
G: GND
AO: ALARM OUTPUT
G: GND
MIC: AUDIO INPUT
G: GND
SPK: AUDIO OUTPUT
G: GND