Publicité
Les langues disponibles
Les langues disponibles
Trouble shooting guide
THINGS TO CHECK
PROBLEM
Is fabric selector set to off?
Is iron plugged in correctly?
Iron does not heat
Is Auto shut-off system activated?
Is iTouch™ switch set to off?
Scorch guards do
Is iron plugged in correctly?
not come out
Is handle activated?
Is iron hot enough?
Iron does not
steam
Is steam selector set to off?
Is steam valve clogged?
Is iTouch™ off, and iron is horizontal?
Iron leaks
Is iron is hot enough?
Has steam burst button been overused?
Iron is emitting a brown
Is water hardness too high?
or white substance
Maintenance/Cleaning
The soleplate should be cleaned if starch or other residue builds up. When the iron is cool, wipe the soleplate with a soft, damp
cloth. Do not use abrasive cleaners or scouring pads as this will damage the iron's soleplate.
Mineral deposits from tap water can occur in the soleplate vents. To clean, fill the water tank and heat the iron to the linen fabric
setting. Once the iron is fully heated, unplug the iron and hold over a sink. Press the steam button repeatedly until water begins to
drip out of the soleplate. Be careful, as this creates large amounts of steam.
To ensure optimal steam production, the steam valve should be regularly cleared of accumulated debris and minerals. This is done
by moving the steam selector back and forth from the off (
© 2011 Oliso Inc. All rights reserved. iTouch, Flip Funnel, and Smart Iron are trademarks of Oliso Inc. Oliso is a registered trademark of Oliso Inc. U.S. Patent No. #6,453,587
B1, #6,925,738 B2, #7,406,783 B2, #7,546,701 B2. Patent Pending #40000079 Printed in China F<07/14>
SOLUTION
Turn the fabric selector knob to a fabric setting.
Check to make sure the plug is fully plugged into the socket.
Touch the handle.
Set the switch on the back of the iron to the ON position.
Check to make sure the plug is fully plugged into the socket.
Move your hand away from the iron, and the iTouch™ Technology will raise the sole-plate.
The fabric selector must be set to the wool, cotton or linen settings to produce
continuous steam.
Steam selector must be turned to a setting.
Move the steam selector from off (
unclog.
When the iTouch™ switch is set to OFF, always store the iron in the vertical position. We
recommend turning on the iTouch™ Technology to store the iron.
Make sure the fabric selector knob is set to the cotton or linen range to ensure proper
steam production.
Allow 3 seconds between uses of the steam burst function.
Switch to either spring water or half tap/half distilled water mixture. See the "water
tank" page for more information.
) to the max (
) steam settings several times.
) to the max (
) settings a few times to
5
Publicité
