T-Fal Optigrill Smart Mode D'emploi page 17

3
...Cooking
to
and
nce
to
grill
Successive cooking
hed
grill
If you wish to cook larger quantities, set in temperature the appliance again (see section 2.
The
«Preheating», starting from point 4), even if cooking the same type of food or same programme.
cle
Cooking larger quantities of food:
Once your first batch of food has finished cooking:
1. Make sure that the appliance is closed and no remnants of food remain inside.
2. Select the correct cooking mode or programme (this step is necessary even if the
cooking mode is the same as for the foods you have just finished cooking).
3. Press the button «OK» to begin preheating. While preheating, the
light indicating the level of cooking will blink purple.
4. Once preheating is complete, the appliance will beep and
the indicator light will stop blinking purple.
5. The appliance is ready to be used once preheating is complete.
Open the grill lid and place the food inside the appliance.
the
Important:
the
- Please note that preheating is required for each new cooking of food.
vel
Reminder: before activating preheating, make sure that the appliance is closed and no
an
remnants of food remain inside.
ds.
- Then wait for preheating to finish before opening the grill and placing food inside.
e to
Note : if the new preheating cycle is activated immediately after the end of the preceding cycle,
ng.
the preheating time will be reduced.
ing
the
ain
efer
18
18 Close the appliance. The control panel
will light up and set itself to 'choice of
program' mode.
Comment: the security system will turn
off automatically if no program selection
is made.
17