Control Panel Operation - M-Spa B-090 Manuel De L'utilisateur

CONTROL PANEL OPERATION

7
6
5
ON/OFF Button:
ON/OFF
Bubble Button:
for 10-mintues feature. The light of Bubble button displays green when activated.
Filter Button:
filtration system is activated. FILTER light will be off when temperature reaches pre-set level.
NOTE: Filtration cannot be turned off when Heating is activated.
Heater Button:
same time. The heater will heat the spa water until the water temperature reaches the pre-set
temperature. After the current water temperature drops 3.6°F(2°C) below the set temperature,
the heating system will restart automatically. When the HEATER button is red, the heating
system is activated. When the HEATER button is green, the heating system is at rest as the
filtration system is inactivated or the water is at the set temperature.
Temperature Button:
SET temperature when press Temperature Button once, and then shows CURRENT water
temperature after 1 second.
NOTE: the default temperature is 100°F (38°C).
NOTE: Temperature adjustment ranges from 68°F(20°C) to 104°F(40°C).
Temperature Adjustment Buttons:
Button for 3 seconds, LED starts to flash, then you can set your desired temperature by
pressing Increase or Decrease buttons. After desired temperature is set, you can press
TEMPERATURE button again, or wait for 3 seconds to see the current water temperature.
Celsius/Fahrenheit Toggle button:
ºC
or Fahrenheit. The system's default is Celsius.
ºF
1 0 4
F
To active the control panel.
To active the bubbling massage function, which has a 20-minutes auto off
Active the filter pump. The light of the Filter Button displays green when the
Use this button to active the HEATING and FILTRATION function at the
To display the water temperature. The control panel displays the
19
1
1. ON/OFF Button
2. Bubble Button
2 3. Filter Button
4. Heater Button
3
5. UP & DOWN Button
6. Temperature Button
4
7. Celsius/Fahrenheit Toggle Button
To adjust the temperature. Press TEMPERATURE
The temperature can be displayed in either Celsius