Spa Set-Up - M-Spa B-090 Manuel De L'utilisateur

SPA SET-UP

1. Move the entire package to the selected site. Open the carton carefully as it can be used to store the spa
during long term storage or when not in use.
2. Lay out all the parts on the ground and make sure all parts are accounted for. Make sure the spa tube is
right side up. (*For missing or damaged part, contact the MSpa Service Center)
3. Spread the Heat Preservation Ground Mat over a cleared area. Spread out the spa liner over the ground
mat. Heat Preservation Mat prevents heat loss from the bottom of the unit.
NOTE: The heat preservation ground mat is not included for the MSpa LITE package . We suggest to find
a ground mat and put it between the ground and spa tub to help prevent scratch and heat loss.
1
NOTE:
Nest B-100: For this model, a side bar is included in the
package. Set up the wicker bar and place the supporting
legs underneath the spa tub before filling the water. It helps
keeping the oval spa in a proper shape after water filling
and inflation.
Alpine B-090/091, Soho
B-091A: Spread out the
square ground mat and
place it to the selected site.
Make sure the buckle of
cover and mat is attached
when spa not in use.
4. Connect the digital cable. Find the digital cable as well as the digital cable gard cover and self-tapping
screw. Get the digital cable through the gard cover, loose the cap on the end, and plug into the cable port
on the control panel. Once the cable is connected properly, power is ON, a yellow signal will light up
beside the ON/OFF button on the panel. Then secure the gard cover onto control panel by using a Phillips
screw driver to tighten the self-tapping screw down to the hole in digital cable gard cover accordingly. Drill
slowly until the screw stops and complete the assembly. Do not diassemble the gard cover including
storage purpose!
4
2
15
3
this side
face down