M-Spa B-090 Manuel De L'utilisateur page 14

Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
and / or service.
Additional requirements for indoor installation
Verify the supporting floor can support the filled weight of spa with maximum number of occupants. Check
with a qualified contractor or structural engineer to verify the requirement.
Make sure the floor is water resistant and provides non-slip surface. Do not install the spa on a carpet of
any other material that could damaged by the moisture.
Humidity is a naturally side effect of indoor spa installation. The room shall be properly ventilated to allow
moisture to escape. Install a ventilating system to prevent excess condensation moisture in the room.
Additional requirements for outdoor installation
Make sure to set up the spa on a firm, level and smooth surface that is strong enough to support the full
weight of the filled spa and maximum occupants.
Do not set up the spa on grass or dirt, as this increases the amount of debris entering the spa, and damage
the spa floor.
Do not leave the spa tub exposed to direct sun light for extend period of time.
It is the possible to install and leave the spa outside at a temperature not lower than 39°F(4°C) and the water
inside the circulation system, pump, pipe are not frozen. Put a Heat Preservation Mat (*Optional) in between
the spa bottom and the ground to prevent heat loss from the bottom of the spa and to provide better heat
retention.
GFCI Testing
Risk of electric shock: This product is provided with a GFCI located at the end of the power cord. The GFCI
plug must tested before each use. Do not use the spa if the GFCI plug does not function properly. Disconnect
the power cord until the fault has been identified and corrected. Contact a licensed electrician to correct the
fault. There are no serviceable parts in side the GFCI plug. Opening the GFCI plug will void the warranty.
1. Plug the machine into the mains.
2. Press the RESET button on the GFCI. The indicator turns red.
3. Press the TEST button on the GFCI. The GFCI indicator should shut off. If the GFCI indicator does not turn
off, the GFCI is faulty.
Do not use the spa. Contact a qualified electrician to correct the fault.
4. Press the RESET button on the GFCI again. The indicator should turn red. If yes, the spa is ready for use.
1.
WARNING
2.
RESET
TEST
RESET
14
3.
RESET
TEST
TEST
4.
RESET
TEST
Indicator area