Dampcomat HWO 1200 SUPER Manuel D'instructions page 25

0-10 meters: 4 x 1,5 mm² and 10-25 meters: 4 x 2,5 mm²
▪ If the supply cord is damaged, it must be replaced by a special cord or
assembly available from the manufacturer or its service agent; and should not
change the length of the cable.
▪ To reduce the risk of electrocution, don't start and run the machine in the rain
or storm. Keep all connections dry and off the ground. Do not touch plug with
wet hands. It is strictly prohibited to let water leak into the machine.
▪ When the machine is running, please maintain a constant water supply.
Without water circulation will damage the sealing rings of the machine.
▪ The inlet water pressure should keep between 0,1 bar – 0,4 bar.
▪ Don't start and run the machine in a place where the temperature is below
0 ºC, to prevent the machine from the freezing current.
▪ This appliance has been designed for only using cleaning water, do not use
corrosive chemicals. Ask your dealer which cleaning agent to use.
▪ Do not use the appliance unless you are wearing protective clothing, safety
goggles and ear protectors. Do not use the appliance in the area of people
who do not wear this protection.
▪ High-pressure jets can be dangerous if subject to misuse. The jet must not be
directed at persons, live electrical equipment or the appliance itself. Pressure
washers should not be pointed at tire walls, as it may be possible to damage
them.
▪ Do not direct the jet against yourself or others in order to clean clothes or
footwear.
▪ Disconnect from the electrical power supply before carrying out user
maintenance or when moving the machine to another job.
▪ To ensure the appliance safety, please use only original spare parts from the
manufacturer or approved by the manufacturer. Do not use the machine
before you changed them if they are damaged.
▪ Incorrect fuels shall not be used, as they may prove hazardous.
▪ Do not spray flammable liquids in the area of the high-pressure cleaner
because of the risk of explosion.
▪ Beware of the danger of the kickback force on the spray assembly when
opening the trigger gun and grasp the gun with hands firmly.
23