After Working - Dampcomat HWO 1200 SUPER Manuel D'instructions

the machine. We advise you not to use powder agents in the internal tank because
of deposit.
The water connection between tap and cleaner is made by connecting the
coupling (fig. 1;10) and opening the tap. Open the water supply tap (and main
cock) widely, so that the cleaner gets sufficient water.
Connect high pressure hose with gun by means of screw couplings to the cleaner
(fig. 1;11). Check whether the main switch (fig. 1;18) is off. Make electric connecti-
on by putting the plug (fig. 4;231) into a socket with marginal earth (CE 3P + N + A
16 Amp.).
By switching on the main switch
trigger of the spouting gun you will get a water beam. On the pressure gauge (fig.
1;16) you can read the pressure of the water. You can change the pressure by
turning the pressure regulator on the spouting gun. Of course, never higher than
200 bars/psi. Left for lower pressure, right for higher. When you stop spraying, the
machine keeps on running and will stop after +/- 30 seconds.
If hot or luke-warm water is preferred, put thermostat (fig. 1;19) on the desired
temperature. Then turn the main switch to pos. 2
(fig. 3;134) starts operating and does so till the wanted temperature is reached. If
the temperature drops, the burner starts again.
To use soap during washing, with both hot or cold water, open dosaging cock (fig.
1;20). To the lift is suction from soap tank and to the right is suction through
external soap hose and can
a short period of time, the water and soap mix will spray out of the spouting gun.
After the dosaging cock is closed, it takes a while before all detergent has left the
machine. Wait until clean water comes out before you stop the machine.

4.1 AFTER WORKING

Before the machine may be stopped, remember to:
close detergent dosaging cock and wait until clean water comes out.
Put main switch to pos. 1
while.
when danger of freezing, let antifreeze into the machine.
Now you can switch of the main switch.
Remember to close water supply before you take off the water supply-hose.
Before you can take off the high pressure hose, first you have to release pressure
from the hose by pulling the trigger of the spouting gun. Pressure now escapes
and couplings can be loosened very easily. Do not place spouting gun with its top
on the floor. The nozzle can get damaged or dirt can get in.
the machine will run. By squeezing the
. Soap is now sucked in by the pump. After
and let cold water run through the machine a
21
(heating). Then the burner