Everpure ViruPure VP-100-QC Mode D'emploi page 4

INSTALLATION INSTRUCTIONS
Tools Needed For Installation
Phillips Head Screwdriver
Adjustable Wrench
Tube Cutters or Utility Knife
Towel
Pencil
Tape Measure
Safety Glasses
Drip Pan and Rags or Towels
1. OPEN CARTON AND INSPECT PARTS
NOTE: This system does not include a delivery faucet. To
complete the installation, purchase a faucet with a stem
that allows installation of the supplied 3/8" faucet adapter.
Installation Parts
Key Description
1 VP-100-QC Filter Head/Bracket
2 Replacement Filter Cartridge,
Model V-500
3 Cover
4 Angle Stop Valve Adapter
5 Tubing, 3/8"
6 Flush Valve Kit, 3/8"
7 Faucet Adapter, 3/8"
8 2 Screws
9 Everpure Filter Timer
2. VERIFY UNDER-SINK MOUNTING LOCATION
A. Measure up 20" (508 mm) from the base of the cabinet.
Place a mark on the wall of the cabinet. This mark is one
of the two screw locations.
B. Create a second mark horizontally 1-3/4" (44.5 mm) from
the first. Use the two marks and start two mounting
screws for the mounting bracket. Tighten the screws until
a small gap 1/16" to 3/32" (1.5 to 2.3 mm) is left between the
screw head and the cabinet wall.
3. MOUNT FILTER HEAD
Arrows on the top of the filter head indicate the direction of
flow.
C. Locate the bracket with the mounting holes over the
screws.
D. Drop the bracket over and down on the screws.
E. Tighten screws as needed.
4
1
1
4
Part No.
SH357296-06
EV979826
7
EV313140
EV312939
EV544600
EV313013
EV312938
EV313150
2
EV907570
A
2
5
8
B
20 inches
(508 mm)
2-1/2 inches (63 mm)
3
6
9