CHIEF MI300i Mode D'emploi page 28

1
The latch sticks out on the lock side
2
The lever must be in the rear position stop (~120°)
3
The arrows must be aligned
4
Tilt the arm about 15° and remove it from its housing (the pins must slide into the groove)
3
MECHANICAL OVER-OPENING OF THE ARM
To open the arm and gain easier access to the bodywork, activate the over-opening by pressing the clamp button (FIG 2 -10).
1
Press the button (FIG 2 -10)
2
The latch sticks out on the open lock side
3
The lever must be open (~90°) at the stop on the latch.
4
The arrows must not be aligned
Incline the arm.
4
LOCKING / UNLOCKING OF THE GYROSCOPE
When the lever is tilted down, the gyro is locked.
28
2
4
1
3
1
2
MI300I 220V
1
When the lever is tilted upwards, the gyro is unlocked.
It can rotate around the clamp at a 360° angle.
2
4
3
1
3
4
2
EN