Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION – PRODUCT OPERATION
Only qualified personnel authorised by the manufacturer should perform the installation of the welding equipment. During the installation, the
operator must ensure that the machine is disconnected from the mains. Connecting generators in serial or in parallel is forbidden.
EQUIPMENT DESCRIPTION (FIG-1)
This machine is designed to carry out the car body repair operations described below :
- spot welding on sheets using a pneumatic clamp,
- welding of sheets using a gun,
- welding of nails, rivets, washers, studs, mouldings,
- repair of bumps and impacts (hail impacts with the pliers option).
1-
SD card reader
2-
Interface (MMI)
3-
Cooling unit
4-
Overhanging arm locking support
5-
Regulator
DESCRIPTION OF THE G CLAMP (FIG-2)
1-
Arm locking/unlocking lever
2-
Cooling pipe
3-
Gyroscope
4-
Pneumatic body
5-
Over-opening electrode
6-
Mobile arm
Clamp opening : push the button (FIG 2 - 10), the opening of the clamp can be released. The electrode retracts in the clamp leaving a space of
80 mm to access the welding area instead of 20 mm when not in use.
ACCESSORIES AND OPTIONS
Coolant CORAGARD CS
330 - 10 l
CEL052246
Caps sharpener
CEL048966
POWER SUPPLY
• This equipment is designed for use only on a three-phase electrical installation between 200 V and 240 V (50-60 Hz) with four wires and a neutral
connected to earth with a 60 A circuit breaker delayed curve D (or fuse type aM).
The permanent current absorbed (l1p or ILp) displayed in the section «technical specifications» of this manual relates to use at maximum power.
Check that the power supply and its protection (fuse and/or circuit breaker) are compatible with the current needed by the machine. In some
countries, it may be necessary to change the plug to allow the use at maximum settings.
• Check the cross-section of the power lead, recommended cross-section is 4x16 mm
10 m, use a conductor with a cross-section of 25 mm² (4AWG).
18
MI300I 220V
40 caps
x 18
x 10
CEL048935
CEL050068
Pressure sensor
Welding test case
CEL052314
CEL050433
6-
Fan
7-
Breaker
8-
Power cord
9-
Filling cap
10-
Cooling liquid gauge
7-
Side handle
8-
Locking latch
9-
Gyro lock/unlock mechanism
10-
Over-opening button
11-
Spot welding button
12-
Remote settings button
Protective cover
x 18
x 6
CEL050853
Europax anti-corrosion
CEL052758
(4x6AWG). If the electrical cable from the panel is longer than
2
EN
SD card inclu-
Overhanging
ding automatic
balancing
programs
system
10>14 kg
CEL050914
CEL059696
Publicité
