General Information; Safety Instructions - Thermo Concepts NORDiK Manuel D'instructions

11. Re-install the floater. Make sure that the opening of the floater
faces upward.
12. Re-install the drip tray.
13. Insert the no-spill cone on the water cooler (with the blue filter in
place) pressing it down and strongly enough so that it engages
all around. The locking mechanism assures the end-user that the
cone remains on the water cooler when the bottle is removed.
14. Re-install the black ring, by placing it on top of the cooler hous-
ing, then turn it clockwise so that it locks in position;
15. Install the water bottle. Wait until the reservoir is full (no more air
bubbles in the bottle) and check to make sure there are no leaks.
16. Plug in the cooler.
GENERAL INFORMATION
Setting the temperature (cold water):
delivery, the thermostat is set at about 7°C (45°F). For colder water,
adjust the thermostat, placed behind the water cooler, by turning the
screw clockwise with a flat screwdriver. Caution: we suggest short
rotation movements, equal to about 5 minutes on a clock, and after
each turn, assess the result. Turning the adjustment screw of the
thermostat one quarter of a turn could cause the water to freeze.
Hot water temperature: The water cooler (with the optional hot
water tank) provides hot water set at about 87°C ± 3°C (188°F ± 5°F).
The thermostat on this unit is not adjustable.
Other issues:
If the water cooler will not be used for an extended period of time, or
if you plan on moving it or if you have to ship it somewhere, follow
these simple instructions:
During inspection before
32
1. Disconnect the unit.
2. Remove the water bottle from the cooler. Even if the bottle is not
empty, the splash-free cap will close when the bottle is removed,
thus no water will be spilled on the floor.
3. Empty the cooler completely through the two faucets.
4. If you have the hot water option, empty the hot-water tank through
the drain hose located behind the cooler.
5. Clean the unit by following the instructions provided in the
section C) Cleaning the Nordik/Pacifik/Baltik cooler.
6. Dry the water cooler thoroughly.
7. Reinstall the different parts in the appropriate places.
8. Never use the faucets as handles because this might cause
damage to the faucets and/or the fittings, which could lead to
leaks.
9. Always transport or store the water cooler in a vertical position.

SAFETY INSTRUCTIONS

➛ Do not connect the unit immediately after moving it if it was
stored horizontally. Wait at least one hour.
➛ Do not place the unit close to a heating device or in
sunlight.
➛ Only water should be used with this
liquid.
➛ Never keep the unit in a horizontal position, not even for storing
or shipping.
➛
IMPORTANT: ALWAYS DISCONNECT THE UNIT WHEN THE
RESERVOIR IS EMPTY FOR A CERTAIN PERIOD OF TIME.
➛ Never immerse the hot-water tank.
➛ In
order to avoid any risk of electric shock or fire, always connect
the water cooler directly into a 120V AC (or 220V AC) grounded
outlet (no extension cords).
➛ Do not pinch, tie or twist the power
➛ Do not
unscrew the faucets if the unit contains any water.
direct
cooler, no other type of
cord set.
33