Hot And Cold Model - Thermo Concepts NORDiK Manuel D'instructions

* The warm-water faucet (white
tab) or the hot-water faucet (red
tab) goes in the left hand socket
(facing the cooler). Insert with
nozzle at 270°, push hard and
turn counter-clockwise.
13. Re-install the floater. Make sure that the opening of the floater
faces upwards.
14. Insert the no-spill cone on the water cooler (with the blue filter in
place), pressing it down and strongly enough so that it engages
all around (tab should be facing front of cooler). The locking
mechanism ensures the end-user that the cone remains on the
water cooler when the bottle is removed.
15. Re-install the black ring, by placing it on top of the cooler hous-
ing, then turn it clockwise so that it locks in position;
16. Install the water bottle and check for leaks (See section "Start
using the cooler", paragraph 3).
17. Plug the cooler to a power outlet.
b) Hot and Cold Model
For the Hot & Cold model, you should not
reservoir; it can be cleaned with a cleaning solution on a clean
cloth. Start with the hot-water tank first, so go to the next para-
graph.
Hot water tank
We recommend cleaning the hot water tank at least once a year.
Because the water is maintained at high temperatures, the risk of
bacteria being present is quite low. However, in many areas of the
world, it is necessary to drain out the mineral deposits because
they can disrupt the temperature readings and lead to over-heating
of the water.
remove the cold-water
28
1. Unplug the cooler.
2. Remove the bottle.
3. Empty the hot water by draining it through the hose that is locat-
ed near the rear grill.
4. Empty the cold-water reservoir, using the cold-water faucet (blue
trim).
5. Remove the ring on top of the cooler.
6. Remove the "no-spill" cone by strongly pulling it upwards by the
tongue located on one side of the cone. Then, remove the blue
part (filter), which must not be cleaned with the no-spill cone. The
filter should either be cleaned with a wet rag or replaced;
F I L T E R
7. Remove the floater inside the cold-water reservoir. Do not remove
the diffuser tube.
8. Remove the drip tray in front of the cooler.
F I L T E R
29