T+A P 1260 R Mode D'emploi page 38

Loudspeaker and signal cables
Loudspeaker cables and signal cables (inter-connects)
have a significant influence on the overall reproduction
quality of your sound system, and their importance
should not be under-estimated. For this reason 
recommends the use of high-quality cables and
connectors.
Our accessory range includes a series of excellent
cables and connectors whose properties are carefully
matched to our speakers and electronic units, and which
harmonise outstandingly well with them.
For difficult and cramped situations the  range also
includes special-length cables and special-purpose con-
nectors (e. g. right-angled versions) which can be used
to solve almost any problem concerning connections and
system location.
Mains cables and mains filters
The mains power supply provides the energy which your
sound system equipment needs, but it also tends to
carry interference from remote devices such as radio
and computer systems.
Our accessory range includes the specially shielded
'POWER FOUR' mains cable, ready-to-use 'POWER
LINE' mains cable with integrated shell-type filters and
the 'POWER BAR' mains filter distribution board which
prevent electro-magnetic interference from entering your
Hi-Fi system. The reproduction quality of our systems
can often be further improved by using these items.
If you have any questions regarding cabling please refer
to your specialist  dealer who will gladly give you
comprehensive expert advice without obligation. We
would also be happy to send you our comprehensive
information pack on this subject.
Mechanical de-coupling
The quality and characteristics of the base on which your
high-quality Hi-Fi equipment stands define the limits of
sound quality which can be achieved. The base surface
should be as heavy, rigid, hard and level as possible.
This amplifier is supplied with the new  damping
cones. This feet feature internal damping qualities which
effectively de-couple the unit from the base surface.
Note:
If the base surface is uneven you can screw the standard
feet in or out to set the unit exactly level.
All units must be adjusted so that they are exactly hori-
zontal in all directions. Check that all feet make solid
contact with the base surface, i.e. that there is absolutely
no tendency for the unit to wobble.
38