Klarstein EL PASO Mode D'emploi page 11

4
Insert the male connector
into the female connector
(from the remote control
receiver to the fan, and
from the remote control to
the terminal block.
7
Fasten the blade
assembly to the motor
with the screws and
spring washers already
attached to the motor.
10
Install the light bulb.
5
Connect the wires from the
earthed mains supply to
the terminal block.
8
Connect the light kit by
clipping together the
two plastic male/female
connectors.
11
Install the lampshade
onto the lamp gallery by
rotating the lampshade
clockwise.
6
Lift up the canopy into
place over the mounting
plate. Ensure that you do
not trap any wires.
9
Fit the light kit to the
switch housing by using
the three light kit-fixing
screws and star washers.
Ensure that you do not
trap any wires.
EN
11