General Safety Rules; Description; Protections; Aerial Noise - Rancilio ROCKY Emploi Et Entretien

1. GENERAL SAFETY RULES

● The packing elements (plastic bags, expanded
polystyrene, nails, cardboard, etc.) must not be left
within the reach of children, as they are potential
sources or danger.
● Check that the data on the machine corresponds to
those of the electrical supply network, before
connecting the equipment.
● It is advisable to unwind the supply cable for the
whole length to avoid twisting or damages. Do not
place the cable near water, liquids or heat sources.
The cable must not be damaged (should the cable
be damaged, contact qualified personnel to replace
it as the use of a special tool is required).
● It is inadvisable to use adapters, multiple sockets
and/or extensions. When their use is indispensable,
only products with certificate of quality (e.g. IMQ,
VDE, +S, etc.) may be used. Check that the voltage
capacity limit indicated on the adapters exceeds
the absorption capacity (A = ampere) of the
equipment.
● In doubt, request an accurate check of the plant by
qualified personnel. The wiring system must comply
with the following safety regulations:
- efficient earth connection;
- section of conductors suitable for absorption
capacity
- efficient earth leakage protection circuit breaker.
● Do not install the machine in the proximity heat
sources (oven, cooking stove, fireplace, etc.) and
in conditions in which the temperature may not go
below 5°C. IT MUST BE PROTECTED AGAINST
FREEZING CONDITIONS.
● Do not leave the machine exposed to atmospheric
agents (rain, sun, etc.) and do not install in damp
rooms such as bathrooms.
● In the event of parts replacement, request original
spares from an authorized retailer or dealer.
● Keep the packed machine in a dry place, not exposed
to atmospheric agents and in conditions in which
the temperature may not go below 5°C.
Do not stack more than three items of the same
kind. Do not place heavy items on the packaging.
Erroneous installation may cause damage to
people and things for which the manufacturer
cannot be considered responsible.
28

2. DESCRIPTION

2.1 Features
The machine is composed of a single structure for
coffee grinding and dosage.
The machine has a cast aluminium structure and
plastic panelling.
The coffee beans are held in a hopper fitted with a lid.
When the machine is turned on, the grinding device
under the hopper is activated. The ground coffee is
collected in the front container, from where the coffee
doses may by taken by activating a hand lever.

2.2 Protections

All moving parts are inside the machine panelling.
In the bean container 1 (Fig.3) a protection is fixed
with screws to protect your hands when filling and
cleaning the bean container.

2.3 Aerial noise

In working place the noise level does not generally
exceed 70dB(A).

2.4 Vibrations

The machine is supplied with rubber vibration
suppressing feet. In normal working conditions, the
machine does not produce vibrations harmful to the
operator and the environment.