Table des Matières
Publicité
ENGLISH
Safety instructions
The appliance is not to be used by children or
persons with reduced physical, sensory or
mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction.
Children should not play with the machine,
whether they are supervised or unsupervised.
Do not leave the packing elements (plastic
bags, expanded polystyrene, nails, cardboard,
etc.) within the reach of children, as these
elements are potential sources of danger.
Do not place heavy items on the packaging.
Do not stack more than three items of the
same kind.
Do not obstruct the suction and dispersion
grilles. Do not cover with cloths, etc.
If the machine freezes, leave the machine in a
place with a minimum temperature of 20°C
for at least 20 minutes before switching it on.
Keep the packed machine in a dry place, not
exposed to environmental elements and in
conditions in which the temperature does
not go below 5°C.
Never put any vessels filled with liquid on
top of the machine.
Improper installation and use can cause
damage to people, animals and things for
which the manufacturer cannot be
considered responsible.
Install the machine on a water repellent
surface (laminate, steel, ceramic, etc.) away
from heat sources (oven, cooking stove,
fireplace, etc.) and in conditions in which the
temperature may not go below 5°C. KEEP
WARM. Place on even surface.
Do not leave the machine exposed to
environmental elements or place them in
damp rooms such as bathrooms.
Switch off the appliance and disconnect from
power supply before changing accessories or
approaching parts that move in use.
Only use original spare parts in order to
avoid compromising the safety and proper
functioning of the machine.
In an emergency, such as fire, unusual noise,
overheating, etc., take immediate action,
disconnect the power.
When in doubt, request a detailed diagram
of the supplied power from a qualified
electrician.
Adaptors, multiple sockets and/or extensions
must not be used.
Before connecting the equipment, check if
the data on the machine corresponds to your
electrical power supply.
The power supply must be provided with the
following safety devices: efficient grounding
connection; section of conductors suitable
for absorption capacity; efficient grounding
leakage protection circuit breaker.
If the power supply cable to the machine is
damaged it must be replaced by the
manufacturer or his service personnel or an
authorized electrician in order to prevent any
risks.
The machine has to be connected to the fixed
installation using a UL listed grounding type
plug of proper rating. Plug shall be selected
and installed only by qualified personnel. (For
US and Canada only).
Installation and first start up must only be
carried out by a trained service technician
with due regard to all local installation
regulations.
Leave enough free space around the machine
to facilitate its use and the performance of
any maintenance operations.
The machine must not be set up in areas
where water tubes or high-pressure cleaners
are in use!
A qualified electrician must make all
electrical connections.
A power switch (mains switch) and / or an
electrical socket must be connected, and
readily accessible, near the machine.
The power switch must isolate the machine
completely from the power supply. The gap
between the contacts must be at least 3mm.
3
Publicité
Table des Matières
