Assembly And Setup; Models 5002 And 5702 Stand-On Scales - Welch Allyn 5002 Mode D'emploi

Assembly and setup

The scale is fully assembled at the factory and tested. In some instances, the scales are
shipped assembled. However, due to size and shipping restrictions, most scales are
partially disassembled. If assembly is required, it can be done with common hand tools.
When special tools are required, they are supplied with the scale. Ensure that all bolts
and fasteners are securely tightened.
Use the following instructions to assemble and setup your scale for use.
Note

Models 5002 and 5702 stand-on scales

1. Carefully remove all parts from the shipping carton and inspect the components for
shipping damage.
2. Place the scale base on the floor or on a workbench.
3. Remove the bolts and washers from the rear of the scale base.
4. Insert the mast into the base. Ensure that the readout display is facing the patient
when the patient stands on the scale.
5. Fasten the mast with the bolts and washers removed in Step 3.
6. Tighten the bolts securely to ensure that a solid connection is made.
Weighing deck mounting (model 5702)
1. Position the weighing deck so that the two sets of holes are closest to the mast.
2. Line the weighing deck up with the mounting holes in the aluminum plate.
3. Install the four flat head screws through the weighing deck.
4. Securely tighten the supplied mounting screws with the provided hex key.
Handrail mounting
1. Attach the handrail to the top of the weighing platform using the button head screws
and the provided hex key.
Three screws are required for each mounting plate (six total screws).
2. Tighten all six screws securely to ensure a safe and stable handrail.
If your scale requires assembly, make sure that the serial number of the
mast and the serial number of the base match when assembling.
9