Publicité
Les langues disponibles
Les langues disponibles
trouble shooting guide
PROBLEM
iron does not heat
Lifters do not
come out
iron does not steam
iron leaks
iron is emitting a brown
or white substance
10
ThINgS TO ChECk
fabric selector is set to off
iron not plugged in correctly
auto shut-off system is activated
Auto-Lift switch set to off
iron not plugged in correctly
handle activated
iron is not hot enough
steam selector set to off
steam valve is clogged
Auto-Lift is off and iron is
horizontal
iron is not hot enough
steam burst button is overused
water hardness may be too high
SOLUTION
Turn the fabric selector knob to a fabric setting.
Check to make sure the plug is fully plugged into the socket.
touch the handle.
Set the switch on the back of the iron to the on (
Check to make sure the plug is fully plugged into the socket.
Move your hand away from the iron, and the Auto-Lift
System will raise the sole-plate.
The fabric selector must be set to the wool, cotton or linen
settings to produce constant steam.
Steam selector must be turned to a setting.
Move the steam selector from off (
settings a few times to unclog.
When the Auto-Lift switch is set to off (
the iron in the vertical position. We recommend turning on
the Auto-Lift system to store the iron.
Make sure the fabric selector knob is set to the cotton or
linen range to ensure proper steam production.
Allow seconds between uses of the steam burst function.
Switch to either spring water or half tap/half distilled water
mixture. See the "water tank" page for more information.
) position.
) to the max (
)
), always store
Publicité
