Troubleshooting; Accessories And Spare Parts - Resol SBS 2000 Manuel Pour Le Technicien Habilité

5

Troubleshooting

Problem
Pump does not prime
Pump does not build up pressure
Pump cannot be switched on
6

Accessories and spare parts

When ordering spare parts, state the serial number
of the SBS2000.
1 Filling and fl ushing unit Article no. 29001340
2 Lid Article no. 28005030
3 2 x Wheel Article no. 28004420
4 Fill / Drain valve Article no. 28005040
Drain valve for the tank
5 Hose set Article no. 28005010
including:
1 × fl ushing hose, 3,1 m
1 × pressure hose, 2,2 m
6 Ball valve Article no. 28005060
for pressure or fl ushing hose
7 Dirt fi lter Article no. 28005050
8 Extension cable Article no. 28005070
5 m, DE version
Possible causes
• Pump defective
• Flushing hose or dirt fi lter blocked
• Too much air inside the pump
In this case, the pump can be vented by means of
the screw at its front side (see fi g.)
• Pump defective
• Pressure hose blocked
• Pump overheated (115 V~ version only)
The overheat protection (thermistor) has been
triggered. Wait until the pump has cooled down,
then push in the overheat protection.
2
1
8
vent screw
overheat protection
(thermistor)
7
5
4
3
6
15