Installation and maintenance manual
4.3
Device mounting and connection
The device must be installed on a stable, flat floor
surface that is not subject to vibration.
/50
4.4
Water supply connections
Connect the cold water inlet and the outlet pipes
to the appropriate connection points (Fig.5).
The table below shows the characteristics of the
connection points.
MOD.
Inlet cooling water
Recirculation
Outlet heating water
Condensate drain
Fig. 5 – Water supply connections
160 / 200 /
UM
260
G 1
"
G 3/4
"
G 1
"
G 1/2
"
The following illustration (Fig. 8) shows an example
of a water supply connection.
1 Shut-off valve;
2 Check valve
3 Safety valve
4 Expansion vessel
5 Drain tap
6 Ricirculation pump
7 Check valve
8 Automatic thermostat mixing equipment
Fig. 6 – Example of the water supply system
pag. 11 / 23