Publicité
Les langues disponibles
Les langues disponibles
Secure the wall brackets to the wall, by using the anchors and
screws supplied with the appliance (FIG.6 A).
Hook the hood to the wall brackets previously fixed (FIG. 6).
SLTC93 MATERA - SLTC94 BARI - SLTC97 BERGAMO -
SLTC103 VICENZA
Tighten the two screws into the wall bracket (fig. 7 A ), which
are necessary to make the appliance adhere to the wall; then
check that the hood is perfectly flush with wall, otherwise act
on the screws shown in fig. 7 B, as follows tighten the screw if
you need to lift the corresponding side, or unscrew it in case
you need to reduce the height.
Carry out the electrical connection, by using the appropriate
power cord.
Only for SLTC93 MATERA and SLTC94 BARI models: open the
front panel by rotating the lower part upwards , as shown in (fig.
8 and fig. 9).
Remove the grease filter in order to reach the appliance inner
side. The grease filter is removed by following the instructions
given in the maintenance section.
Definitively secure the product to the wall by using the screws
provided, as shown in fig. 10.
Refit the grease filter and close the front panel.
7
Publicité
