Control Panel - Franke FDW 908 IB XS Mode D'emploi Et Installation

USE
Button Function
A The button only works when the door is open.
Press Briefly = Turns the Lights On/Off at maximum
intensity.
Press and hold for 2 Seconds = Turns the Courtesy lights
On/Off.
B Door Open or Closed
Press briefly = performs a
alarm.
Door Open or Closed
Press and hold for 2 Seconds = Enables/Disables the
Activated Charcoal Filter Alarm with the Motor turned
off and no Filter Alarm triggered.
C Door Open.
Press briefly = Activates/Deactivates Delay mode,
causing automatic shutdown of the Motor and the
Lighting system from any speed with a 30' delay. It is
disabled by pressing the same button again, turning the
motor off or closing the door.
Works both with Door Closed and Open with Motor +
Lights = Off.
Press and hold for 4 Seconds = Enables/disables the
Keyboard Lock.
Only works with the Door Open.
D
Press briefly = Enables/Disables the Intensive speed. This
speed is timed to run for 10 minutes. At the end of this
time the system will return to the speed set previously.
It is disabled by pressing the same button again, turning
the motor off or closing the door.
E Only works with the Door Open = increases the working
speed.
F Only works with the Door Open = decreases the working
speed.
G Only works with the Door Open.
Press briefly = Turns the Motor off
Door Open or Closed
Press and hold for 2 Seconds with Motor and Lights Off =
Enables/Disables the Remote control.
H Door Open = Closes the Door + Lights and Motor Off
(*)
Door Closed = Opens the Door + Lights and Motor On.
Warning: If the Door remains partially open for any
reason, press the Button to complete the opening or
closing cycle.
(*) While the Door is Closing it will block in an
intermediate position after approximately 6 seconds. To
finish Closing you must press the button again and hold it
until the door is completely closed.
EN

Control panel

Reset
of the Filter saturation
LED button
After 100 hours in operation the Drop symbol is
displayed to indicate saturation of the Metal Grease
Filters.
After 200 hours in operation the letter
indicate saturation of the Activated Charcoal filters.
Symbol C flashes twice = A.C. Filter Alarm Activated
Symbol C flashes once = A.C. Filter Alarm Deactivated
Clock symbol.
Displays the
All the LED buttons flash twice. During the Lock the LED
buttons light up in sequence.
I symbol.
Displays the
The number of lighted segments increases.
The number of lighted segments decreases.
LEDs turn off
LED keys flash twice = Remote control Enabled
LED keys flash once = Remote control Disabled
C
is displayed to
1 16