Siemens S18ID Série Notice D'utilisation Et De Maintenance page 23

Fault
The dispenser light does not
function.
The ice maker is not producing
enough ice or the ice cubes are
misshapen.
Ice is forming in the supply hose
to the ice maker.
Water is flowing out of the
appliance. Close shut-off
valve immediately.
Possible cause:
The bulb is defective.
The water pressure is too low.
The freezer compartment temperature is
too low.
Change the water filter.
The water pressure is too low.
The freezer compartment temperature is
too low.
The water pipe in the appliance is
defective.
The water pressure is too low.
A wrong water valve has been installed.
Remedial action
Change the bulb (see "Changing the bulb").
Check water pressure. The water pressure must
be between 25 and 120 p.s.i. (1.72–8.25 bar).
Check temperature of the freezer
compartment. If required increase the
temperature.
Instructions for changing the water filter can be
found in the section "Water filter".
Check water pressure. The water pressure must
be between 25 and 120 p.s.i. (1.72–8.25 bar).
Check temperature of the freezer compart-
ment. If required increase the temperature.
Call customer service immediately.
The valve may leak if the water pressure is too
low. The water pressure must be between
25 and 120 p.s.i. (1.72–8.25 bar).
Self-tapping valves and 3/16 inch (4.76 mm)
saddle valves reduce the water pressure and
may eventually block the pipe.
23