Siemens S18ID Série Notice D'utilisation Et De Maintenance page 22

Fault
Small ice cubes over a prolonged
period.
Condensation forms on the
dispenser unit.
Ice cubes have an unpleasant
odor/flavor.
Ice maker is not producing any
ice.
Ice is not dispensed.
22
Possible cause:
Wrong water pressure.
A wrong water valve has been installed.
The ice maker is switched off (see
"Switching off the ice maker"). The
condensation heater does not function.
Ice which is stored for a long time may
absorb odors which impair their taste.
The ice cube container is dirty.
Unsealed packages in the freezer transfer
odor/flavor particles to the ice cubes.
The ice cube container is in the false
position.
The water pressure is too low.
The freezer compartment temperature is
too high.
A wrong water valve has been installed.
The agitation function in the ice cube
container is switch off. The filling level
sensor is blocked.
Two ice cubes can by chance be
attached to each other. These ice cubes,
when joined together, can block the ice
chute so that no further ice can be
dispensed.
Remedial action
Check water pressure. The water pressure must
be between 25 and 120 p.s.i. (1.72–8.25 bar).
3
Self-tapping valves and
saddle valves reduce the water pressure and
may eventually block the pipe.
You have to activate the condensation heater.
Switch on the ice maker.
Simultaneously hold down the lock out
and the agitation buttons for 3 seconds.
The water light and the ice cube light flash
twice.
The ice maker is switch off and the
condensation heater works.
To re-activate the condensation heater:
Simultaneously hold down the lock out
and the agitation buttons for 3 seconds.
The water light and the ice cube light flash
once.
Dispose of old ice cubes. Use the ice maker
more frequently.
Empty and wash out the ice cube container.
Check whether the frozen food has been
packed in airtight containers. Clean the inside
of the appliance. See section on "Odors".
Reinsert the container and slide it backwards to
the end position (see section "Variable interior
design").
Check water pressure. The water pressure must
be between 25 and 120 p.s.i. (1.72–8.25 bar).
Check temperature of the freezer compart-
ment. If required, lower the temperature.
Self-tapping valves and 3/16 inch (4.76 mm)
saddle valves reduce the water pressure and
may eventually block the pipe.
Pull-out and empty the ice cube container.
Remove the ice on the sensor.
Open the door.
Remove all of the ice out of the ice chute.
/ inch (4.76 mm)
16